Structure - MTX FHS-2000 User Manual

9
Do not install the fan heater at distance less than 0.5 m from flammable objects (synthetic materials, furniture,
curtains, etc.) and in the immediate vicinity of a power outlet.
Do not place objects on the fan heater to avoid fire. Do not block inlet and outlet holes of fan heater.
Do not immerse the fan heater in water or any liquid. Operation of the fan heater in rooms with high humidity
is not allowed (e.g. swimming pool, bath).
In case liquid gets on the device, immediately turn it off. Do not touch fan heater with wet hands.
Periodically check the device and the power cord for possible damage. Do not use the appliance with a
damaged power cord.
Before starting cleaning or maintenance, as well as during a long break in operation, unplug the appliance by
unplugging the plug. You must remove the plug directly; never pull the plug by pulling on the cord.
Before connecting the device to the network, make sure that the mode switch is in the position
In case malfunctions are detected, stop using the device and contact the service center. To repair the fan
heater is not recommended.
Fan heater can be used only vertical position.
Do not carry the fan heater by the power cord. Also forbidden to disconnect the device from network, holding
it by network cable. When disconnecting the device from network, hold on to the plug.
Not use fan heater in rooms with area of less than 4 m2.
2
5
Temperature controller allows you to set the desired temperature level. Device has 3 operating modes: ventilation
mode, warm air mode and hot air mode. Power in the second and third heating mode is 1000W and 2000W
respectively. Fan heater has a light indicator that lights up when turned on. If there is no need for a heater, turn
the mode switch
This model is equipped with a protection system that turns off fan heater when overheating. Before switching on
again, disconnect the device from the power supply, allow device to cool, then reconnect.
SPIRAL ELECTRIC FAN HEATER
3
1
4
and unplug the device.

STRUCTURE

1. Power cord
2. Temperature controller
3. Handle
4. Mode switch
5. Network indicator
Mode switch has 4 positions:
OFF
Ventilation mode
Warm air mode
Hot air mode
Matrix
Tools for
eXistence
.