Cleaning And Replacing The Filter - Shark IQ ROBOT AV970 Series Owner's Manual

MAINTENANCE

CLEANING AND REPLACING THE FILTER

For optimal suction power, regularly clean and replace the filter inside the robot's dust bin.
See sharkaccessories.com for replacement filters.
IMPORTANT: DO NOT use water when cleaning the filter.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove dust and debris.
NOTE: Make sure to insert the dust bin completely, until it clicks into place.
s h a r kc l e a n . c o m
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot.
MAINTENANCE
SELF-CLEANING BRUSHROLL
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue cleaning to allow the brushroll to clean itself.
To access the brushroll, push up on the tabs on the
brushroll access door, then lift off the door.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
NOTE: When cutting away debris, be sure not to cut the brushroll.
Lift out the brushroll. Clean off any debris from the
brush roll.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
s h a r kc l e a n . c o m