Toshiba PORTEGE R35-C User Manual page 76

5.
If the disc is not seated properly when the disc tray is closed, the disc might
be damaged. Also, the disc tray might not open fully when you press the
eject button.
Removing discs
To remove the disc, do the following:
Do not press the eject button while the computer is accessing the optical
disc drive. Wait for the optical disc drive indicator to go out before you open
the disc tray (only for R30-C/A30-C). Also, if the disc is spinning when you
open the disc tray, wait for it to stop before you remove it.
1.
When the disc tray pops open slightly, wait a moment to make sure the
disc has stopped spinning before pulling the disc tray fully open.
2.
3.
How to remove disc when the disc tray will not open
Pressing the eject button will not open the disc tray when the computer
power is off. If the power is off, you can open the disc tray by inserting a
slender object (about 20 mm) such as a straightened paper clip into the
manual eject hole near the eject button.
1. Manual eject hole
Product appearance depends on the model you purchased.
User's Manual
Push the center of the disc tray to close it. Press gently until it locks
into place.
To pop the disc tray partially open, press the eject button. Gently pull
the disc tray out until it is fully opened.
The disc extends slightly over the sides of the disc tray so you can
grasp it. Gently lift out the disc.
Push the center of the disc tray to close it. Press gently until it locks
into place.
Figure 4-6 Manual release with the eject hole (R30-C/A30-C)
Φ1.0mm
1
4-15