Get Started; Charge The Battery; Pair The Headphones With Your Mobile Phone - Philips TAN4207 User Manual

3 Get started

Charge the battery

Note
 Before you use your headphones, place them in
the charging box and charge the battery for
two hours for optimum battery capacity and
lifetime.
 Use only the original USB charging cable to
avoid any damage.
 Finish your call before charging. Connecting the
headphones to charge will power them off.
Connect the supplied Type C charging
cable to:
• Type C charging slot on the headphones
and;
• The charger/USB port of a computer.
LED turns white during charging
and turns off when the headphones
is fully charged.
Tip
 Normally, a full charge takes 2 hours.
Pair the headphones with
your mobile phone
Before you use the headphones with your
mobile phone for the �rst time, pair it
with a mobile phone. A successful pairing
establishes a unique encrypted link
between the headphones and mobile
phone. The headphones store the last 4
devices in the memory. If you try to pair
more than 4 devices, the earliest paired
device is replaced by the new one.
1
Make sure that the headphones are
fully charged and turned off.
2
Press and hold
blue LED �ashes.
3
Make sure that the mobile phone is
turned on and its Bluetooth feature is
activated.
4
Pair the headphones with the mobile
phone. For detailed information,
refer to the user manual of your
mobile phone.
The following example shows you how to
pair the headphones with your mobile
phone.
1
Activate the Bluetooth feature of
your mobile phone, select
Philips TAN4207.
2
Enter the headphones' password
"0000" (four zeros) if prompted. For
those devices featuring Bluetooth
3.0 or higher, there is no need to
enter a password.
for 4 seconds until the
Philips TAN4207
EN 5