P.I.T. PHP170-C Operation Manual page 8

Step 2
Attach the hook to the handle as shown, then
tighten the screw with a screwdriver. Screw
the washer handle tight to the main body as
below fi g. The screws will be packed together
with the main body, pls kindly check and fi nd
it when unpacked.
Step 3
Insert the adjustable spray nozzle(H) into
the gun. Push and turn the adjustable nozzle
clockwise onto the gun(G) until hand tight to
lock it in place. When the pieces are joined
properly, you cannot separate the two compo-
nents by pulling straight out on the adjustable
nozzle. All attachments must be inserted into
the gun for proper use.
Step 4
Attach the high pressure hose(E) to the
gun(G). Insert and quick-connect it tight to
avoid leakage.When the pieces are joined
properly, you cannot separate the two compo-
nents by pulling straight out from the gun(G).
Push the hose lock button, then you can pull
out high pressure washer.
ST4.8*20
Step 5
Attach the high pressure hose(E) to the
pressure cleaner water outlet. Insert and
quick-connect it tight to avoid leakage.When
the pieces are joined properly, you cannot
separate the two components by pulling
straight out from the water outlet. Push the
"Button" according to the direction of arrow,
then you can pull out the high pressure hose.
Stpe6
Attach the hose connector to pressure wash-
er. Before attaching the connector to the
male fi tting, remove the plastic cap, which is
inserted onto the male fi tting on the pressure
washer before shipping. This plastic cap
can be discarded once removed. After both
components have been installed, attach the
garden hose with connector screw on the
pressure washer. Connect the garden hose to
the waterspout.
Stpe7
If the water source is lower than the machine
inlet, the water drop to the machine inlet shall
7
High Pressure Cleaner