Distributor Repair; Remove; Install - Yale GDP16-20AF Maintenance Manual

Distributor Repair

1. PULLEY
2. SHAFT AND
BEARING
ASSEMBLY
Figure 46. Water Pump
NOTE: This section only has the removal and installa-
tion procedures for the distributor. Service procedures
for the ignition system are found in the Electrical Sys-
tem section.

REMOVE

1. Rotate crankshaft until No. 1 piston is at TDC on
compression stroke. Make note of position of dis-
tributor rotor. See Figure 48.
2. Disconnect wires at spark plugs.
3. Remove capscrew from flange of distributor shaft
housing. Lift distributor assembly from engine.

INSTALL

1. Rotate crankshaft until No. 1 piston is at TDC on
compression stroke. Put rotor in correct position.
See Figure 48.
2. Lubricate O-ring and gear on distributor engine oil.
Install distributor, making sure to align marks on
distributor housing, distributor gear, and engine.
3. Connect wires at spark plugs.
20
3. WASHER
4. HOUSING
5. SEAL
6. IMPELLER
Distributor Repair
1. TENSIONER
2. SPRING
Figure 47. Timing Belt Installation
Figure 48. Distributor Replacement
600 YRM 496
3. LOCK BOLT
4. TENSION SIDE