Chapter 5 How to use the Wireless Utility(Access Point)
5.1 Introduction
To set your TBW-103UB as an Access Point (AP) , reference In Access Point
mode , your TBW-103UB as an AP. This allows you to set up your wireless
network without using a dedicate AP device. Up to 16 wireless station can
associate to TBW-103UB.
Additional Setup Requirement
To bridge wireless and wired using the TBW-103UB, The following requirement
must be met.
1. The TBW-103UB must be installed a computer connect to the wired network.
2. Either configure network sharing or bridge the two interfaces (Wireless & Wired)
on the computer.
3. Set the wireless station's IP address to be in the same subnet as the computer
in which TBW-103UB is installed.
5.2 The 802.11g Wireless Utility Screen
5.2.1 Select "ACCESS POINT" in the MODE field to display the screen as shown.
5.2.2 click "More Setting..."in the TBW-103UB screen to display the screen as
shown.
ACCESS POINT Mode
10
TBW-103UB User's Guide