Yamaha Stratoliner XV19CTSV Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
When the key is turned to "ON", the fuel
gauge needle will sweep once across
the fuel level range and then return to
the current amount in order to test the
electrical circuit.
NOTE:
G
Do not allow the fuel tank to empty
itself completely.
3
G
The fuel gauge does not indicate
the correct fuel level for the first 5
km/h (3 mi/h) after refueling.
Odometer, tripmeter, and
modes
1. Odometer/tripmeter/fuel reserve tripme-
ter/clock
Push the "SELECT" switch to switch
the display between the odometer
mode "ODO", the tripmeter modes
"TRIP 1" and "TRIP 2" and the clock
mode in the following order:
ODO → TRIP 1 → TRIP 2 → Clock →
ODO
If the fuel level warning light comes on
(see page 3-2), the odometer display
will automatically change to the fuel re-
serve tripmeter mode "F-TRIP" and
start counting the distance traveled
from that point. In that case, push the
"SELECT" switch to switch the display
clock
between the various tripmeter, odome-
ter, and clock modes in the following or-
der:
F-TRIP → TRIP 1 → TRIP 2 → Clock
→ ODO → F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" switch, and then
push the "RESET" switch for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically, and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
Clock mode
1. Clock
To set the clock:
1. Push the "SELECT" switch to
2. Push the "SELECT" and "RESET"
3. When the hour digits start flashing,
4. Push the "SELECT" switch, and
5. Push the "RESET" switch to set
6. Push the "SELECT" switch and
3-5
change the display to the clock
mode.
switches together for at least two
seconds.
push the "RESET" switch to set the
hours.
the minute digits will start flashing.
the minutes.
then release it to start the clock.