The following images indicate the location of the 2280 solid-state drive that is installed in M.2 slot and provides a visual
representation of the installation procedure.
Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 solid-state drive slot.
2. Slide the M.2 2280 solid-state drive into the M.2 solid-state drive slot on the system board.
3. Place the solid-state drive thermal plate over the solid-state drive.
4. Align the screw holes on the solid-state drive and thermal plate with the screw hole on the palm-rest and keyboard
assembly.
5. Replace the two screws (M2x3) that secure the 2280 solid-state drive and thermal plate to the palm-rest and keyboard
assembly.
Next steps
1. Install the
microSD
card.
2. Install the
base
cover.
3. Follow the procedure in
Memory
Removing the memory modules
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
base
cover.
About this task
NOTE:
The system supports two memory slots.
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
card.
computer.
computer.
Removing and installing components
25