Infrared Data Communications - Panasonic CF-25LJF8EAM/E Operating Instructions Manual

Infrared Data Communications

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Your computer is equipped with an infrared communications port enabling you to transfer data
without a cable.
Preparations for Infrared Data Communications
Set the address of your infrared communications port to enable.
Position your computer so that the port is face-to-face with the port of another com-
puter.
Be sure the computers are not in di-
rect contact with one another.
A port-to-port distance of 20 to 50
cm (8 to 20 inches) is recommended.
C A U T I O N
In the Setup Utility, select [IrDA] in [Supervisor Setup] and set [Automatic (PnP)] or
[2F8]. Setting [OFF] will make infrared data communications impossible.
Problems with infrared data communications
An object is located between both ports.
There are other electronic devices nearby causing interference, such as a television,
VCR, wireless headphone, etc.
Direct sunlight or white glowing light, such as fluorescent lighting; can cause inter-
ference with communications between the ports.
Running TranXit
TranXit comes preinstalled and allows you to perform infrared data communications, such
as the transfer of data or the updating of information between two computers. Note that both
computers need to have TranXit installed and running.
Running the program
Select [TranXit] from [Start] -
[Programs] - [TranXit].
N O T E
Online help is available on how to use
TranXit. Click [TranXit Quick Reference
Guide] in [Start] - [Programs] - [Panasonic].
(Installing TranXit
Setting or changing the "Computer Name"
It is necessary to assign a different "Computer Name" to each computer; select [Com-
puter Name] in [Setup] to change the name.
C A U T I O N
In [Control Panel], if [Infrared] is enabled, TranXit can not be used. For TranXit to
be operable, [Infrared] must be disabled.
Exit TranXit before entering the suspend or hibernation mode. Start TranXit again
after the computer resumes.
Infrared Communication Port
T M
page 35)
2 1