Panasonic CF-25LJF8EAM/E Operating Instructions Manual page 15

Computing On the Road
Battery Status
1 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Use the Battery Indicator to Check on the Battery Status
( page 15)
B a t t e r y I n d i c a t o r
O r a n g e *
G r e e n *
R e d
B l i n k i n g r e d *
B l i n k i n g o r a n g e f o r 5
s e c o n d s a f t e r t h e A C
a d a p t e r i s c o n n e c t e d *
B l i n k i n g o r a n g e * *
B l i n k i n g g r e e n * *
*
When the AC adapter is connected, you must wait a few seconds before the LED indicator turns on.
** Only using CF-VZS250A or CF-VZS252 (Ni-MH).
N O T E
When using the optional CD-ROM pack:
Recharging is temporarily stopped when the drive is being accessed. In the case, the battery
indicator goes off temporarily. In addition, recharging is temporarily discontinued when the CD-
ROM autoplay function is enabled. For more information, please read the operating instructions
that is supplied with the CD-ROM pack.
Getting a detailed reading
N O T E
When the battery indicator remains red (or a 99% reading is displayed) for an
extended period of time, the actual remaining battery level and the displayed
level may differ. Should this occur, charge the battery until the indicator is green,
then completely discharge the battery.
When the battery pack is not in the computer,
When the Remaining Battery Charge Becomes Low
Perform the following:
Plug in the AC adapter, and fully charge your battery.
Use a spare battery if you have one.
If you have neither the AC adapter nor an extra battery, power the computer off or do
not power on.
If the hibernation function is set
Red indicator lights
Beep sounds**
(at approx. 9% capacity)
**
When disabling the speakers with the Setup Utility (or pressing
disabled.
If the hibernation function is not set
Red indicator lights
(at approx. 9% capacity)
B a t t e r y S t a t u s
Charging
Fully-charged
Battery charge is low (the charge is less than approx. 9% capacity)
Battery pack or charger may not be working properly.
Check your connections. If the problem persists, consult your
nearest Panasonic dealer.
Unable to recharge due to violation of temperature limits
( page 15)
Refreshing
Refreshing required
90 ~ 100%
65 ~ 90%
35 ~ 65%
10 ~ 35%
Hibernation Mode
(at approx. 4% capacity)
Beep sounds
(at approx. 4% capacity)
+
[Blinking]
The battery pack is not installed or
the remaining battery charge is not
known.
is displayed.
+ ), the warning beep is also
C o m p u t e r
goes off
(at approx. 0% capacity)