Table of Contents
Advertisement
en-us Troubleshooting
Issue
Display flashes.
All LEDs light up or
flash.
UP appears on the
display.
Water is left in the
appliance at the end
of the program.
Appliance cannot be
switched on or oper-
ated.
52
Cause and troubleshooting
Appliance door is not closed properly.
Close the appliance door.
▶
Arrange the dishware so that no parts
‒
project beyond the rack and prevent the ap-
pliance door from closing properly.
Electronics have detected a fault.
Press the main switch button for approx. 4 sec-
1.
onds.
→ "Controls", Page 13
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Unplug the power plug or switch off the cir-
‒
cuit breaker in the fuse box.
Wait at least 2 minutes.
‒
Switch on the circuit breaker in the fuse box
‒
or plug in the power plug.
Switch on the appliance.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 56
A software update is available.
Press the remote start button to install the soft-
▶
ware update.
a After a successful software update, "Suc" ap-
pears on the display for a few seconds.
Filter system or area under the filters is blocked.
Clean the Filters → Page 40 .
1.
Clean the Drain pump → Page 54 .
2.
Program has not yet ended.
Wait until the program ends or terminate the
▶
program with Reset.
→ "Terminating the wash cycle", Page 32
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the power cord plug or switch off the
1.
breaker.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
Advertisement
Table of Contents
