Back Panel Connectors - Gigabyte TRX50 AERO D User Manual

2-6

Back Panel Connectors

Q-Flash Plus Button
Q-Flash Plus allows you to update the BIOS when your system is off (S5 shutdown state). Save the latest
BIOS on a USB thumb drive and plug it into the Q-Flash Plus port, and then you can now flash the BIOS
automatically by simply pressing the Q-Flash Plus button. The QFLED will flash when the BIOS matching
and flashing activities start and will stop flashing when the main BIOS flashing is complete.
SMA Antenna Connectors (2T2R)
Use this connector to connect an antenna.
Tighten the antennas to the antenna connectors and then aim the antennas correctly for better
signal reception.
USB 3.2 Gen 2 Type-A Port (Red)
The USB 3.2 Gen 2 port supports the USB 3.2 Gen 2 specification and is compatible to the USB 3.2 Gen 1
and USB 2.0 specification. Use this port for USB devices.
Line Out
The line out jack.
Mic In
The Mic in jack.
DisplayPort In port
The DisplayPort In port offers video outputs to the motherboard. Refer to the pictures below and the
USB4 USB Type-C
®
Step 1:
Connect the included DisplayPort cable from
the graphics card to the DisplayPort In port on
the back panel.
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
(Note)
port (DisplayPort) for more information.
®
Step 2:
Then connect the USB Type-C
devices to USB4
(DisplayPort) to complete.
- 15 -
or DisplayPort
®
USB Type-C port
® ®