Advertisement
Available languages
Available languages
Connection:
Use wire on the back of the speaker in the output tab of the amplifier (or amplifiers of radio). The
speaker wire is on one side red and on the other one black. Connect to the red side of the amplifier
and speakers (+) tab. Connect one end of the black side (-) in the other tab. Connect each speaker
to make sure that is not (+,-) inverted polarity. If the polarity of the speakers is reversed, the sound
will be unnatural and will play without bass
Underpower Vs. Overpower:
1. Most speaker damage is caused by amplifiers with too little power (wattage).
2. An overdriven amplifier clips the waveforms and leads to speaker distortion.
3. Clipping is usually audible and it may vary from a harsh sound to a fuzzy or unclear sound.
4. Damage caused by operating the speakers at distorted volume levels is not covered by the
warranty.
5
Advertisement
