IKE Phase 1
If you selected IKE, the following screen is displayed after the Traffic Selector screen. This
screen sets the parameters for the IKE SA.
IKE Phase 1 (IKE SA)
Local Identity
Remote Identity
Figure 53: VPN Wizard - IKE Phase 1 Screen
This setting must match the "Remote Identity" on the remote VPN.
Select the desired option, and enter the required data in the "Local
Identity Data" field.
•
WAN IP Address - This is the most common method. If se-
lected, no input is required.
•
Fully Qualified Domain Name - enter the Domain Name
assigned to this device.
•
Fully Qualified User name - This name does not have to a valid
Internet Domain Name. E-mail addresses are often used for this
entry.
•
DER ANS.1 DN - This must be a DER ANS.1 Domain Name.
This setting must match the "Local Identity" on the remote VPN.
Select the desired option, and enter the required data in the "Remote
Identity Data" field.
•
IP Address - This is the most common method. If selected, no
input is required.
•
Fully Qualified Domain Name - enter the Domain Name
assigned to this device.
•
Fully Qualified User name - This name does not have to a valid
Internet Domain Name. E-mail addresses are often used for this
entry.
•
DER ANS.1 DN - This must be a DER ANS.1 Domain Name.
Microsoft VPN
83