Related Manuals for Gamma Nano Beam
Summary of Contents for Gamma Nano Beam
- Page 1 Nano Beam 60w LED Beam with RGBW Color Mixing User Manual Nano Beam – GAMMA LED Vision Page 1 of 13...
-
Page 2: Table Of Contents
DMX Modes and Configuration........................10 Standalone Mode and Configuration......................11 3. Maintenance................................12 Routine Maintenance............................12 Troubleshooting Problems..........................12 A. The unit does not work:..........................12 B. Not Responding to the DMX Controller....................12 4. Technical Specifications............................13 Nano Beam – GAMMA LED Vision Page 2 of 13... -
Page 3: Introduction And Setup
Introduction and Setup Unpacking and In the Box Thank you for choosing our Nano Beam. For your own safety, please read this manual before installing or using the device. This manual covers the important information on installation and applications. Please install and operate the fixture with following instructions. Meanwhile, please keep this manual for future needs. - Page 4 Don’t try to modify the fixture without any instruction by the manufacturer. Warranty is voided if there are any malfunctions from not following the user manual while operating or any hazardous operation, like shock short circuit, electronic shock, lamp broken, etc. Nano Beam – GAMMA LED Vision Page 4 of 13...
-
Page 5: Customer Support
Customer Support WARRANTY POLICY GAMMA LED Vision warrants its products for the periods set below from the date of purchase to be free of manufacturer and workmanship defects. Warranty does not cover normal wear and tear caused by force, negligence or misuse of products. GAMMA LED Vision is not responsible for any damages or injury caused by misuse or improper handling of the products and in accordance with instructions and specifications of manual. -
Page 6: Setup And Operation
UP and DOWN buttons to select the sub menu, press the ENTER button to save the settings or automatically return to the previous menu. Press the MENU button to return, or wait for one minute and then exit the menu mode automatically. Nano Beam – GAMMA LED Vision Page 6 of 13... -
Page 7: Menu Operation
Turn the LCD Display On/Off when the menu is not active. Disp On/Off Display Flip – On is for floor-mounted, Off is for Hanging Rpan On/Off Flip Pan Rtil On/Off Flip Tilt Rest Reset the Fixture Nano Beam – GAMMA LED Vision Page 7 of 13... -
Page 8: Dmx Setup
1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at least 110 ohms resistance. Microphone cable is not DMX cable. Please refer to the diagram below: Nano Beam – GAMMA LED Vision Page 8 of 13... - Page 9 XLR plug with a 120 Ω resistor connected between pins 2 and 3, which is then plugged into the output XLR socket of the last fixture in the chain. Please see illustrations below: Nano Beam – GAMMA LED Vision Page 9 of 13...
-
Page 10: Dmx Modes And Configuration
DMX Modes and Configuration The Nano Beam has multiple DMX modes, sometimes called “personalities”, “profiles”, or as we will use here “modes”. In general, modes with more DMX channels offer a greater level of control or options but take up more of your output channels on your lighting console or software. -
Page 11: Standalone Mode And Configuration
Nano Beam is placed into Standalone mode by the on-board menu and keys. There are multiple Secondary unit id’s selected via the menu to make different units sync with each other in different ways. -
Page 12: Maintenance
Plug the light directly into the DMX controller with a cable that you know is good. • Unplug all other lights – does it work? Try to use another DMX controller. • Nano Beam – GAMMA LED Vision Page 12 of 13... -
Page 13: Technical Specifications
◦ Voltage: AC90-240V, 50/60HZ ◦ Light source: 1* 60W red, green, blue, white ◦ Control mode: DMX512, master, slave, voice control; ◦ Pan: 540 ° ◦ Tilt: 270 ° ◦ Wattage: 80w Max Nano Beam – GAMMA LED Vision Page 13 of 13...
Need help?
Do you have a question about the Nano Beam and is the answer not in the manual?
Questions and answers