Advertisement
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
HOW TO USE A HIDDEN CAM & CAM DOWEL
Cam Dowel
Arrow
Metal end
Hidden Cam
3.
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Page 6
FASTENER
®
1.
Push a HIDDEN CAM into
the part. The arrow in the
HIDDEN CAM must point
toward the hole in the edge
of the board.
Start
Arrow
427430
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
2.
Insert the metal end of the CAM
DOWEL into the HIDDEN CAM.
Hole
Tighten
Maximum
210 degrees
Minimum
190 degrees
www.sauder.com/commercial-office/service
Dowel end
Arrow
Advertisement
