Whirlpool AWG812/PRO Health & Safety, Use & Care And Installation Manual page 40

PROBLEM
Spin result poor
Detergent residues on laundry
after wash
Washing machine stands still
during programme / programme
seems not to proceed / during
standstill, animation may appear
on display
Programme duration is longer or
shorter as initially indicated on the
display / in the programme chart .
Door is locked, with or without
failure indication, and the
programme does not run .
Drum light (if available) does not
work anymore .
40
POSSIBLE CAUSE
Spin button was set to a low spin
speed .
Unbalance during spinning
prevented final spin cycle .
Excessive foam formation
prevented spinning .
Too much powder detergent used
/ quality of detergent .
Programme phases without drum
movement .
Excessive foam formation (maybe
by overdosage of detergent)
interrupted the programme . Can
be repeated several times until the
foam reduction is sufficient .
Under- or overvoltage of mains
might be detected .
Washing machine adapts to factors
having an effect on duration, such
as size of laundry load, excessive
foam formation, load unbalance,
prolonged heating time due to
low inlet water temperature etc . .
When programme duration is
recalculated, an animation appears
on the display .
Door is locked in case of power
breakdown .
Washing machine is in a standstill
(as described in previous section
"Washing machine stands still...) .
Water level or temperature too
high, or electrical component
failure .
Light bulb needs to be replaced .
SOLUTION
Select and start "Spin" programme
with a higher spin speed (if
selectable) .
See line above .
Start "Rinse&Spin" programme .
Avoid excessive detergent dosing .
Adjust and use the Dosing Aid
function .
Avoid detergent overdosing
Brush out the fabric .
Use "Intensive Rinse" option (if
selectable) .
Use liquid detergent / use special
detergent for black or dark laundry .
Standstill phases lasting up to
about 2 minutes are normal in
some wash programmes .
The programme continues
automatically, as soon as the foam
reduction is sufficient .
If display shows Fod (=failure
overdosage), refer to table FAILURE
INDICATORS AND MESSAGES .
Programme will automatically
continue as soon as the mains
voltage is in the proper range .
Avoid small laundry loads with
absorbent, big pieces of laundry /
add articles of different sizes .
Avoid detergent overdosing
– respect the dosing
recommendations of the detergent
manufacturer . Adjust and use the
Dosing Aid function .
Programme will continue
automatically as soon as the mains
is available again .
Programme will continue
automatically after the origin of the
standstill does not persist anymore .
See instructions for failure
"Service": doorlock failure" / FdL /
F29 in section Failure indicators .
Call our After-Sales Service to
exchange the light bulb .