Husqvarna 371XP Workshop Manual page 20

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
GB
Ignition system
Dismantling
1. Remove the cylinder cover and starter assembly. See
page 16.
2. Release the blue lead (A) (which connects to the stop
switch) from the ignition module (B). See fig. 1.
3. Remove the HT lead (C) from the spark plug, release
both leads from the cable guide (D) and lift out the cable
guide. See fig. 1.
4. Undo the two M4-bolts and remove the ignition module
(B). See fig. 1.
5. Undo and remove the two pawls (E) for the recoil starter.
See fig. 1.
6. Remove the spark plug and fit the piston stop tool in the
spark plug hole. See fig. 2.
7. Release the flywheel nut. Undo the nut until it is in line
with the thread on the shaft outer end. See fig. 3.
8. Attach the flywheel puller. Tighten down the two M5 x 25-
bolts approx. 10 turns. Tighten the central bolt, while
preventing rotation with the holding tool, until the flywheel
comes loose. See fig. 4.
9. Remove the puller, nut, washer and flywheel.
Cleaning and inspection
Clean all components, especially the tapers on the
flywheel and shaft.
Check that the flywheel is not cracked or damaged in any
other way.
18 – English
ELECTRICAL SYSTEM
www.mymowerparts.com
F
A B E D
Fig. 1
Fig. 2
Fig. 3
Fig. 4
C