Advertisement
Quick Links
Advertisement
Related Manuals for Midas Touch MPL-1000
Summary of Contents for Midas Touch MPL-1000
- Page 1 Fingerprint Identification Padlock MPL-1000 Quick Operation Guide V1.2...
-
Page 2: Limited Warranty
Important information: Please read this claims, before using this product Limited warranty: This warranty stated herein shall NOT apply, if: (1) this Product has not been used in accordance with any accompanying instructions, (2) this Product has not been used for its intended functions and environment, (3) the artificial malicious damage or personal negligence cause any defects, (4) if this Product has been opened, modified or repaired by anyone other than an authorised service centre, or if it is repaired using unauthorised spare... -
Page 3: Charge The Battery
When the battery capacity has reached the warning status of low battery (the red LED flashes 5 times which occurs in fingerprint scanning mode) When the battery capacity is unable to start MPL-1000, charging, just like an emergency power supply for emergency unlock ... - Page 4 Unlock: There are two ways to unlock: (1) In the locked state, press the shackle of MPL-1000 once (as Figure 3) to activate MPL-1000 and then the green LED lights up and begins flashing (flashing time about 5 seconds, but in case the battery capacity reaches the low level, the red LED will light up and flashing 5 times).
- Page 5 The first time you use MPL-1000, we recommend to immediately complete the fingerprint enrollment MPL-1000 will be powered off automatically if no any operations happen till green LED turns off which the fingerprint scanning mode or unlock phase ...
-
Page 6: Fingerprint Enrollment
LED interactive flashing turn off (this available time is approximately 5 seconds, as Figure 6). When your fingerprint is successfully scanned, MPL-1000 will sound a beep and green LED light up once, you can remove your finger. - Page 7 interactively again; repeat steps (2) ~ (3) to register other fingerprints. If you wanna...
- Page 8 MPL-1000 can store up to 30 sets of fingerprints, In case the fingerprints accumulation of a total reaches 30, MPL-1000 will sound 5 beeps and the red LED lights up approximately 5 seconds, and then automatically returns to enrollment mode.
- Page 9 automatically...
- Page 10 In fingerprint enrollment phase, press the shackle and hold until the red LED lights up and then hear a long beep (this period is approximately 2 seconds), then release the shackle. Now, all fingerprints has been cleared, and then MPL-1000 will exit the enrollment phase and automatically power off.
- Page 11 Follow us ��Facebook B2B @ https://www.facebook.com/midastouchinc ��Instagram@ https://www.instagram.com/midastouchinc/ ��Twitter@ https://twitter.com/midastouchinc21 ��Website @ www.midastouchinc.com �� Contact Midas Touch ◻ Inquiry form: Please drop your message to our inquiry form at https://www.midastouchinc.com/inquiry-form/ ✉ Email: Please send your inquiry to contact@midastouchinc.com...
Need help?
Do you have a question about the MPL-1000 and is the answer not in the manual?
Questions and answers