Download Print this page

Midas Touch PL-1000 Quick Operation Manual

Fingerprint identification padlock

Advertisement

Quick Links

Fingerprint Identification Padlock
PL-1000
Quick Operation Guide
V1.2

Advertisement

loading

Summary of Contents for Midas Touch PL-1000

  • Page 1 Fingerprint Identification Padlock PL-1000 Quick Operation Guide V1.2...
  • Page 2: Limited Warranty

    Important information: Please read this claims, before using this product Limited warranty: This warranty stated herein shall NOT apply, if: (1) this Product has not been used in accordance with any accompanying instructions, (2) this Product has not been used for its intended functions and environment, (3) the artificial malicious damage or personal negligence cause any defects, (4) if this Product has been opened, modified or repaired by anyone other than an authorised service centre, or if it is repaired using unauthorised spare...
  • Page 3: Charge The Battery

    When the battery capacity has reached the warning status of low battery (the red LED flashes 5 times which occurs in fingerprint scanning mode) When the battery capacity is unable to start PL-1000, charging, just like an emergency power supply for emergency unlock ...
  • Page 4 Unlock: There are two ways to unlock: (1) In the locked state, press the shackle of PL-1000 once (as Figure 3) to activate PL-1000 and then the green LED lights up and begins flashing (flashing time about 5 seconds, but in case the battery capacity reaches the low level, the red LED will light up and flashing 5 times).
  • Page 5 5 seconds Unlock: green LED lights up for about 5 seconds a beep sounds   The first time you use PL-1000, we recommend to immediately complete the fingerprint enrollment  PL-1000 will be powered off automatically if no any operations...
  • Page 6: Fingerprint Enrollment

    5 seconds, as Figure 6). When your fingerprint is successfully scanned, PL-1000 will sound a beep and green LED light up once, you can remove your finger. (3) Repeat step (2) until you hear a long beep, this means your fingerprint has successfully been enrolled into PL-1000.
  • Page 7 PL-1000 can store up to 30 sets of fingerprints, In case the fingerprints accumulation of a total reaches 30, PL-1000 will sound 5 beeps and the red LED lights up approximately 5 seconds, and then automatically returns to enrollment mode.
  • Page 8  All procedures have the time constraints, please follow the provisions in operation guide  PL-1000 stores up to 30 sets of fingerprints, it can no longer enroll fingerprint  Children's smaller fingers, which can not be effectively covered in...
  • Page 9 Follow us ��Facebook B2B @ https://www.facebook.com/midastouchinc https://www.instagram.com/midastouchinc/ ��Instagram@ ��Twitter@ https://twitter.com/midastouchinc21 ��Website @ www.midastouchinc.com �� Contact Midas Touch ◻ Inquiry form: Please drop your message to our inquiry form at https://www.midastouchinc.com/inquiry-form/ ✉ Email: Please send your inquiry to contact@midastouchinc.com...