Hoover H Series Manual page 106

DISABLING REMOTE CONTROL
To exit remote

"PROGRAMME
ENROLMENT Wi-Fi" again for 3 secs.
When no cycle is under way:

- The Wi-Fi indicator light will start to flash
slowly and the
CONTROL OFF" will appear on the
display.
When a cycle is under way:

- The Wi-Fi indicator light will start to flash
slowly and the
CONTROL OFF" will appear on the
display.
- The message "DOOR OPEN" will appear
on the display.
- The cycle will be completed without
control from the App.
Alternative way to exit remote control.
Press the "START/RESET" button for 3 sec

If there is a cycle under way, it will be
cancelled, and the machine will exit
REMOTE CONTROL mode.
The "Wi-Fi" indicator light will flash
slowly. It is now possible to set a new
wash cycle from the control panel.
control, press
SELECTION button/
message "REMOTE
"REMOTE
message
Press the "ON/OFF" button for 3 secs

(or power off)
If there is a cycle under way, it will be
paused and
REMOTE CONTROL mode.
On switching on again, the "Wi-Fi"
indicator light will flash slowly and any
cycle under way will continue from the
point of interruption.
Opening the
CONTROL will be disabled. To resume
control from the App, close the door.
"Wi-Fi" indicator light
Indicates the connection status of the

product to the home Wi-Fi network. It can
be:
- SLOW FLASHING:
disabled.
- QUICK FLASHING FOR 3 SECONDS,
THEN OFF:
connect to the home Wi-Fi network or
has not yet been enrolled on the App.
- SLOWLY FLASHING 3 TIMES, THEN
OFF FOR 2 SECONDS: enrolment
procedure on the App in progress.
106
the machine will
door, any REMOTE
remote control
the machine cannot
exit