Larson Electronics AML-LED-WP40-M-22C Instruction Manual

Thank you for your purchase of the Larson Electronics AML-LED-WP40-M-22C Automotive Mechanics'
LED Work Light. Please follow the steps below in order to install, operate, and maintain this product.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE AML-LED-WP40-M-22C MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL
CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE THAT ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE, AND
MAINTAIN THIS PRODUCT. IF YOU ARE NOT QUALIFIED OR ARE UNFAMILIAR WITH ANY ASPECT OF THIS
INSTRUCTION SHEET, CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
RISK OF PERSONAL INJURY –
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
MOUNTING
The work light includes the LED light, cord w/ cord cap, trunnion mount w/ magnet, and glare shield.
Ambient Temperature Range: -25°C to +60°C
1. Select a location to install the fixture. This LED work light is IP68 waterproof, vapor proof, and built
to resist the damaging effects of an outdoor environment. This fixture should not be used in areas with
no ventilation or extreme ambient temperatures.
2. Affix the mount to your chosen metal surface. A 200 lb grip magnetic base allows the unit to be
mounted to any metal surface capable of holding its weight. Run power cord to the appropriate
receptacle with the CORRECT VOLTAGE.
3. Lamp Adjustment. The trunnion mount can be attached to the lamp in two locations, the lower area or
middle area on the back of the wall pack. Use the ( 2 screws ❶ ) and ( 2 lock washers ❷ ) for
repositioning the mount as shown in the diagram on page 2. The fixture can be placed in any direction.
WIRING
We strongly encourage a licensed electrician install this product, especially in outdoor locations where
weatherproofing may be required. Universal voltage driver permits operation at 100 V - 277 V AC, 50 or 60
Hz except those factory ordered with low voltage 11 V to 25 V AC/DC.
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light
fixture wires as shown in the diagram 
This unit comes pre-wired from factory with the
selected cord length and cord cap. Take precautionary
steps for weatherproofing all connections if installed in
a location where water may come in contact with the
unit. Ensure the unit is properly grounded.
Larson Electronics, LLC
AML-LED-WP40-M-22C Instruction Guide
40 Watt Automotive Mechanics' Work Light
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
Phone: (800) 369-6671 Fax: (903) 498-3364
AML-LED-WP40-M-22C
www.larsonelectronics.com
200 lb Magnet
1 of 2