Larson Electronics WAL-WBC-500LTL-LED-100 Instruction Manual

500 Watt Portable LED Work Area Light Cart
The WAL-WBC-500LTL-LED-100 Cart Mounted LED Work Area Light from Larson Electronics produces
60,000 lumens of light capable of illuminating an area 38,000 square feet in size. This wheel barrow style LED
light cart is designed for portability and durable operation and ideal for use in demanding conditions.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:

TO AVOID THE RISK OF FIRE OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSPECTED AND
MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALL APPLICABLE ELECTRICAL
CODES.

RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRES
ELECTRICAL SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE RATED LUMINAIRE FIXTURES VOLTAGE.

TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR
SHARP OBJECTS. SUITABLE FOR DAMP LOCATIONS.
CART OPERATION
The wheelbarrow cart assembly consists of 2 parts:
1. Light head
2. Wheelbarrow cart base
 To assemble cart, insert light head over the top center of extension pole and tighten hand screws. The
wheelbarrow cart is now ready for use.
 Tilt cart using both handles and maneuver like a wheelbarrow. Simply roll entire assembly to a new location
once assembled. Make sure light head is secure prior to maneuvering cart.
 Place cart on a flat, even surface to ensure safe operation.
 Power light by toggling power to your receptacle. Light is "instant-on" and will illuminate once energized.
 Adjust lamp vertically by loosening hex bolts on either side. Swing lamp into final position and tighten any
loose bolts.
WARNING: Be sure all hand screws are tight before transporting! Use caution when maneuvering near
inclines or drop offs.
POWER
Included with this LED light cart is 100 feet of SOOW cord which combined with adjustability offered by the
LED light heads provides ample length for cart placement and optimal coverage of the workspace.
 Run power cord to a nearby receptacle outputting voltage listed on product label. This light cart is shipped
with the selected cord cap upon purchase. Make sure the cord cap matches your receptacle prior to
energizing.
WARNING: check nameplate for proper voltage. Damage from improper voltage may void warranty.

Loosen the single hand screw holding light head to rotate horizontally. Be sure all hand screws are tight
prior to transporting!
Larson Electronics, LLC
100ft cord - 60,000 Lumens - 120-277V AC
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
WAL-WBC-500LTL-LED-100
www.larsonelectronics.com 1 of 2