Advertisement
Quick Links
60 Watt Base Stand Work Area LED Light Tower - Quadpod Mount
Thank you for your purchase of the Larson Electronics WAL-QP8-WP60PM-GRC50. Please follow the steps
below in order to operate and maintain this product.
IMPORTANT
READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. WAL-QP8-WP60PM-GRC50 MUST BE OPERATED IN ACCORDANCE WITH NATIONAL ELECTRICAL
CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WARNING:
OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE
TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE.
WARNING:
SUBSTITUTE COMPONENTS MAY IMPAIR SAFETY.
OPERATING
Before operation, confirm that the power source will provide the correct voltage indicated on the product
nameplate. Ensure the receptacle will accept the cord cap attached to the light.
Place the light in the desired location and run its power cord to a power source.
The light head can be adjusted by loosening the screws on each side, positioning the light head and tightening
the screws to hold the light in place.
This light is "instant-on" once plugged in to a live circuit.
AVOID DIRECT EYE EXPOSURE Do not look at the face of or directly into the light when plugging in or when
illuminated.
USE AND CARE
Unauthorized modification may impair the function and/or safety of the extension cord and could affect the life of the
equipment. Always check damaged or worn out parts before using. When not in use, store in a secure place out of the
reach of children. Inspect for good working condition prior to storage and before re-use.
TROUBLESHOOTING
Refer to the guide below or contact the manufacturer if the fixture does not function properly.
Is the correct line voltage being supplied to the fixture?
Is the fixture properly grounded?
Make sure installed power switch is functioning properly (if applicable).
Larson Electronics, LLC
Instruction Manual
60 Watt Portable LED Work Area Light
Phone: (800) 369-6671
Fax: (903) 498-3364
WAL-QP8-WP60PM-GRC50
www.larsonelectronics.com
1 of 1
Advertisement
Related Manuals for Larson Electronics WAL-QP8-WP60PM-GRC50
Summary of Contents for Larson Electronics WAL-QP8-WP60PM-GRC50
- Page 1 WAL-QP8-WP60PM-GRC50 60 Watt Base Stand Work Area LED Light Tower - Quadpod Mount Instruction Manual Thank you for your purchase of the Larson Electronics WAL-QP8-WP60PM-GRC50. Please follow the steps below in order to operate and maintain this product. IMPORTANT READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Personnel Safety
Proceed to step 8. 8. Reapply power to reel. 9. Check for correct voltage at terminal strip. If voltage reading is still incorrect, replace defective collector. 10. Replace access cover. Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 1... -
Page 3: Spring Tension
Maintain reel by following the service instructions given below. Refer all other repairs, other than those listed, only to an authorized service person or directly to Larson Electronics. Failure to do so can result in personal injury and/or equipment damage and may void the warranty. - Page 4 WARNING: DO NOT over extend T-head completely allowing extension pole to free from base! If the T- head becomes free, serious injury or death can occur. Larson Electronics shall not be held liable for injuries caused by misuse.
-
Page 5: Maintenance
Some parts may be sourced locally from your nearby hardware store. WARRANTY Should further information not covered by these instructions be required, please contact Larson Electronics at 1-800-369-6671 or sales@larsonelectronics.com for further assistance. Please visit LarsonElectronics.com for Warranty and Return information.