Suunto Memory Belt User Manual page 12

Heart rate recorder and wireless transmitter

Hide thumbs Also See for Memory Belt:

Table of Contents

If the memory is full, measuring ends and the device switches to sleep mode. This is indi-

cated by 2 long beeps and 2 long, orange flashes. This signal continues until you take off the

belt. You should then download your data to your PC and must empty the belt's memory

before you can continue to use your Suunto Memory Belt to record heart rate data.

NO HEART RATE DETECTION

If, during recording, Suunto Memory Belt no longer detects your heart rate, it will alert you by

2 long beeps and 2 long, green flashes every 30 seconds. As long as there is available mem-

ory, the device will continue to give this warning every 30 seconds while in contact with the

skin. If the belt detects your heart rate again, it will give a medium-length beep and a

medium-length, green flash. If you take the belt off, it will stop recording and go into sleep

mode after 60 seconds. This is indicated by 3 short beeps and 3 short, green flashes.

Table of Contents