Table of Contents
Advertisement
Model T70 Series
CHARGING THE BATTERY PACK
Your radios are equipped for using a rechargeable NiMH battery pack
(BATT10) which can be recharged by inserting one end of the USB
Cable into a USB power source, and the other end into the radio USB
charging jack, or with the optional desktop charger (as described
below). While charging, the Battery Meter will flash from 1 to 3 bars.
The LCD display will show FULL when charging is complete. For
maximum battery life, Midland recommends charging the battery
pack when the low battery icon comes on. Remove the radios from
the charger when the charging is finished.
To charge using the Desktop Charger:
1. Place the BATT10 rechargeable battery packs in the radios.
2. Connect one end of the USB Cable into a USB power source.
3. Insert the other end of the USB Cable into the desktop charger
USB jack.
4. Place the radios into the desktop charger slot. While charging, the
Battery Meter will flash from 1 to 3 bars, and stop when charging
is finished. The LCD display will show FULL.
In order to ensure that the battery pack is fully charged, it is
recommended that the battery pack be charged with the radio
turned OFF.
1. Only use the Midland NiMH battery pack.
!
2. Do not attempt to charge alkaline batteries or any batteries
or battery packs other than the one indicated in the
manual. This may cause leakage and damage to the radio.
3. For long term storage of the radio, turn the radio OFF and
remove the batteries from the radio.
BATTERY LEVEL INDICATOR
Your radio has a BATTERY LEVEL METER
battery power level. The greater the number of bars visible, the
stronger the battery level. When the battery level is low, the Battery
Shell
batteries should be replaced or recharged if using a rechargeable
battery pack.
Page 6
icon and "bt Lo" will flash in the display indicating your
that shows the
midlandusa.com
Advertisement
Table of Contents
