Pc Interface - Suunto Solution Alpha User Manual

30
The principle when adjusting the clock is that the TIME/MODE and COM contact
scroll through the different displays, while ON/PLAN and COM changes the values
of the selected display. In these figures the contacts which are connected are
shadowed.
Thus, to correct the time, do as follows:
1. Activate the Time Setting mode by connecting the TIME/MODE and COM
contacts continuously to scroll through the menu. Release your fingers immediately
when Set appears on the display. The Time Setting display will now be shown.
2. The hour display starts to blink immediately. If you want to change it, keep the
ON/PLAN and COM contacts connected. The hours will start to scroll. Release your
fingers immediately when the correct value is displayed. [To change the A or P for
a.m. or p.m. scroll the hours past 12:00].
3. To scroll through the minute, month, date, and year, keep the TIME/MODE and
COM contacts connected. Release your fingers when the display you wish to
change is blinking. Repeat step 2 to change this value.
NOTE: In case of the minutes, date and year, the change is made separately for
both digits, as shown by the blinking digit. In case of the hours and month, the
complete number is changed simultaneously.
4. Repeat steps 3 and 2 to change any additional values.
5. Restart the clock with the RETURN command, i.e. by connecting
all three contacts at the same time. First make contact between
the ON/PLAN and TIME/MODE contacts and after that with the COM
contact.
If something goes wrong during this procedure, do not perform step 5. Within about
two minutes the SOLUTION á will automatically return to the normal surface mode
and restore the original time setting. You can now repeat the time setting procedure.
If you use the RETURN command, the modified time will be set.
Remember to regularly check that the clock is on time especially when traveling to
different time zones, as the entry time of all dives is stored in the memories.

5. PC INTERFACE

The SOLUTION á can be connected to an IBM compatible personal computer (PC),
using the optional SUUNTO PC interface and its software. With the Interface the
SOLUTION á dive data can be downloaded to a PC. The PC interface software can
be used for educational and demonstrational purposes, for planning dives, as well
as for keeping complete record of your dive history with the SOLUTION á .