Optional Accessories; Rear Handlebars Kit - Baby Lock Gallant XL Instruction And Reference Manual

Optional Accessories

Rear Handlebars Kit

To install the rear handlebars
 NOTE: Make sure that the machine is off
before installing the rear handlebars. The
main power switch must be in the O (off)
position.
1. Slightly loosen the two Philips screws on the
rear handlebars connection cover with a #1
Phillips screwdriver (not provided). Do NOT
remove the screws.
2. Pull off the plastic cover. It protects the rear
handlebars connection. Do NOT remove the
screws.
3. Re-tighten the two screws. They hold the
connection board to the machine.
4. You will need three M5 x 12 SKB ZN screws
for the rear handlebars (included in the Rear
Handlebars Kit package) and a 3mm hex
wrench.
5. Align the three holes in the handlebars with the
holes on the back of the machine.
6. Attach with the three screws. Tighten securely.
To install the laser pin
1. You will need the laser pin, washer and nut.
2. Screw the nut all the way onto the laser pin.
3. Slide the washer onto the laser pin threads and
screw the laser pin all the way into the side of
the machine.
4. While holding the laser pin, firmly tighten the
nut with the 8mm wrench (provided).
| 17
Gallant XL User Manual