Baby Lock Gallant XL Instruction And Reference Manual page 14

Installation and Setup
 NOTE: Refer to the Manual included with the frame for detailed set-up instructions for
the frame.
Carriage
To install the carriage and machine on the frame
1. Place the carriage on the tracks, ensuring that the
stitch regulator faces the back of the frame.
2. Place the machine on the carriage.
U CAUTION: It is suggested to have two people
when lifting the Gallant XL. Always lift from the
throat of the machine, not from the handlebars,
needle bar area or needle bar.
3. Plug the carriage encoder cable into the round jack
on the back of the machine (to the left of the power
cord). Plug the other end into the encoder.
4. Secure the carriage encoder cable through the clip
at the back of the machine. Check that there is no
strain on the cable at the plug into the machine.
5. Plug the machine encoder cable into the round jack
on the right side of the machine (as seen from the
rear of the machine). Plug the other end into the
encoder.
 IMPORTANT: If you ever need to remove
the machine from the carriage, disconnect
the carriage encoder cable from the carriage
encoder. Failure to unplug the cable when
removing the machine from the carriage could
result in damage to the cable or carriage
encoder.
U CAUTION: Never plug or unplug the encoder
cables or any other cables while the machine
is on, as this could potentially cause electrical
damage to the machine or encoders.
Clip
Carriage Encoder
Cable
Steps 3 and 4
Stitch Regulator
with Machine
Encoder Cable
Step 5
Gallant XL User Manual
Stitch
Regulator
| 13