Sony D-E771 Operating Instructions

3-866-696-11 (1)
Compact Disc
Compact Player
Operat ing Inst ruct ions
About area code
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
For accessories supplied with your player, check the area code of your model
and refer to "Supplied accessories" toward the end of this manual.
D-E771
D-E776CK
Sony Corporation ©1999 Printed in Malaysia
For t he cust om ers in t he USA
Welcom e!
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
Thank you for purchasing the Sony
These limits are designed to provide reasonable
Compact Disc Compact Player.
protection against harmful interference in a
Before operating your player, please
residential installation. This equipment
read this manual and retain it for
generates, uses, and can radiate radio frequency
future reference. energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
About t his m anual
However, there is no guarantee that interference
The instructions in this manual are for the
will not occur in a particular installation. If this
D-E771 and D-E776CK. Before you start
equipment does cause harmful interference to
reading, check your model number.
radio or television reception, which can be
determined by turning the equipment off and on,
Ow ner's Record the user is encouraged to try to correct the
The model and the serial numbers are located at interference by one or more of the following
the bottom. Record these numbers in the spaces measures:
provided below. Refer to them whenever you - Reorient or relocate the receiving antenna.
call upon your Sony dealer regarding this - Increase the separation between the equipment
and receiver.
product.
- Connect the equipment into an outlet on a
Model No. __________ Serial No.__________ circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
WARNING
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
To prevent f ire or shock
equipment.
hazard, do not expose
For t he cust om ers in Aust ralia
t he unit t o rain or
The supply cord of the AC power adaptor cannot
m oist ure.
be replaced; if the cord is damaged, the AC
power adaptor should be discarded.
To avoid elect rical
For t he cust om ers not in Poland
shock, do not open t he
The mark on the unit is valid only for
cabinet . Ref er servicing
products marketed in Poland.
t o qualif ied personnel
For t he cust om ers not in Europe
only.
The CE mark on the unit is valid
only for products marketed in the
CAUTION
European Union.
The use of optical instruments with this product
will increase eye hazard.
For t he cust om ers not in Russia
The mark on the unit and package is
valid only for products marketed in
Russia.
Playing a CD right
aw ay!
If you want to play a CD right now, choose to use your player on house
current. Other choices are the following three: rechargeable battery, dry
batteries (see "Power Sources" on the reverse side) and car battery.
1
Connect
to a w all outlet
AC power adaptor
Headphones
DC IN 4.5 V
2/REM OTE
2
Place a CD
Label side up
OPEN
1
2
Slide OPEN to open the lid.
Fit the CD to the pivot.
3
Close the lid.
3
Play
1
Press ^.
2
Adjust the volume.
To stop play, press p.
zOt her Operat ions
To Press
^
Pause
Playing t racks repeat edly
Resume play after ^
(Repeat Play)
pause
You can play tracks repeatedly in normal,
Find the beginning = once**
INTRO PGM, shuffle or RMS (Random Music
of the current track
Sensor) play modes. Repeat all the tracks,
(AMS*)
only one track or the specified part within the
same track.
Find the beginning = repeatedly**
of previous tracks
PLAY M ODE
(AMS)
Find the beginning + once**
of the next track
(AMS)
=/+
+ repeatedly**
Find the beginning
of succeeding tracks
(AMS)
To repeat all t he t racks
Hold down +**
Go forward quickly
Press REPEAT/ENTER during play.
The " " indication appears.
Go backwards Hold down
=.**
quickly
*AMS = Automatic Music Sensor
**These operations are possible during both
play and pause.
To cancel repeat play, press REPEAT/ENTER
again.
If you press REPEAT/ENTER on the player to
display " ", you can locate the tracks
To repeat a single t rack
continuously in the following order:
1 Press REPEAT/ENTER while the track you
• When using +: next track n next track
want to repeat is playing.
...... last track n first track n second track
The " " indication appears.
......
• When using =: previous track n
previous track ...... first track n last track
......
To rem ove t he CD
2 Press PLAY MODE repeatedly until "1"
Remove the CD while pressing the pivot.
appears.
To repeat another track, press = or + .
To cancel repeat play, press REPEAT/ENTER
again.
To repeat t he specif ied part w it hin
Notes on display
t he sam e t rack (LOOP Play)
• When you press ^ (when RESUME is set
1 During play, press PLAY MODE
to OFF), the total number of tracks in the CD
repeatedly until "A˜B" flashes in the
and the total playing time appear for about 2
seconds. display.
• During play, the track number and the
Flashing
elapsed playing time of the current track
appear.
• During pause, the elapsed playing time
flashes in the display.
• Between tracks, the time to the beginning of
the next track will appear with the "–"
indication.
2 Press REPEAT/ENTER to set the point
(point A) where you want to start repeat
Notes on handling CDs
play.
• To keep the CD clean, handle it by its edge.
Point A is stored in the memory.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
Light up Flashing
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
3 Press REPEAT/ENTER again to set the
point (point B) where you want to stop
repeat play.
Point B is stored in the memory, and repeat
play starts from point A.
Light up
To change points A and B, press and hold
REPEAT/ENTER until "A˜B" flashes in the
Not t hese w ays
display, then do steps 2 and 3 again.
To set points A and B on other tracks, press
= or + to select another track, then do
steps 2 and 3 again.
If you press p, the stored points will be
erased. To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
To cancel repeat play, press PLAY MODE
until "A˜B" disappears from the display.
Playing only t he t racks
Playing t racks in t he order
you w ant
(INTRO PGM Play) you w ant
You can choose and play your favorite tracks You can program up to 22 tracks to play in
by scanning through the beginning of each any order you choose.
track in a CD.
PLAY M ODE
PLAY M ODE REPEAT/
ENTER
REPEAT/
ENTER
=/+
+ ^
1
During play, press PLAY MODE
1
During play, press PLAY MODE repeatedly until "RMS*" flashes.
repeatedly until "INTRO PGM" flashes.
Flashing
*RMS = Random Music Sensor
2
Press ^ to start scanning.
2
The player plays about the first 15
Press = or + to choose a track.
seconds of each track and "INTRO PGM"
The track number and the playing order
flashes faster.
appear.
3
Track number Flashing
Press REPEAT/ENTER while the track
you want is playing. To skip the track,
press + or just wait for the next track.
After you have gone through the CD,
"INTRO PGM" stops flashing and the tracks
you have chosen play automatically.
3
To finish programing before going through Press REPEAT/ENTER to program the
the whole CD, press ^. The selected tracks
track.
will be played.
4
Repeat steps 2 and 3 to program the
If you press p, the program will be erased.
remaining tracks.
To prevent accidental erasure, set the
5
RESUME switch at the rear of the player to
Press ^ .
ON.
"RMS" stops flashing and the tracks you
have chosen play in the order you
To cancel INTRO PGM play, press PLAY
specified.
MODE repeatedly until the play mode
indication disappears from the display. If you press p, the program will be erased. To
prevent accidental erasure, set the RESUME
switch at the rear of the player to ON.
Playing t racks in random
To cancel RMS play, press PLAY MODE until
"RMS" disappears from the display.
order
(Shuf f le Play)
To check t he program
You can play the tracks in a CD in random
During programming:
order.
Press REPEAT/ENTER before step 5.
During RMS play:
PLAY M ODE
Press PLAY MODE repeatedly until
"RMS" flashes, then press REPEAT/
ENTER.
Each time you press REPEAT/ENTER, the
track number and the playing order appear in
the order you specified.
Note
• If you program another track after the 22nd
During play, press PLAY MODE repeatedly track, the first track programed is cleared and
until "SHUF" appears. the new track is programed instead.
The tracks play in random order.
To cancel shuffle play, press PLAY MODE
repeatedly until the play mode indication
disappears from the display.
Note
• During shuffle play, you cannot return to
previous tracks by pressing = .
(RM S play)
REPEAT/
ENTER
^
Flashing
Playing order
Continue to the reverse side m