Philips AWH1620/51 User Manual page 15

will turn on the «OptimalTEMP» mode,
in which a fixed temperature of 55 ° C is
set and the average power mode Press
«Mode» again to select «Turbo» mode.
This mode has a fixed temperature of
75 °C and an intensive power mode In
the «OptimalTEMP» and «Turbo» modes,
the temperature and power adjustment
buttons do not work
Indicators:
The water heater automatically maintains the
set temperature
«Heat» - the indicator lights up when the
water in the tank is being heated
«Warm» - the indicator lights up during heat
saving, when there is no heating
Setting the time and timer
1. With the water heater off, press the
«Mode» button to set the time. The time
display "00" will flash on the screen. Set
the desired hour with button
Press the «Mode» button again to set the
minute time
2. Press «Mode» again to set the timer to
turn on heating of water At this time, the
indicator will light up on the screen
Set the desired hour with button
. Then press «Mode» again and enter the
minute time settings After the setting
process is completed, the indicator
will turn off, the set time is automatically
saved
3 To set the timer for heating when the water
heater is on, hold down the "Settings"
button for 3 seconds Using button
, select ON on the screen The water
heater will work in heat saving mode and
heating will start when the set time is
reached After heating is completed, the
appliance will return to the heat-saving
mode To disable this function, hold the
«Settings» button for 3 seconds, then
select OFF on the screen
Regular service maintenance
The « » indicator lights up on the control
panel when regular service maintenance is
recommended
Attention!
Any service work must be carried out by
specialists of authorized service centers
with an appropriate mark in the sheet with
information about the service performed
(p 14)
After completing regular service maintenance,
press and hold the « » button for 3 seconds
to turn off the indicator.
Attention!
During heating, water may start to drip
from the opening of the safety valve
Water leakage cannot be avoided and
must not be prevented, since blocking the
valve can lead to rupture of the internal
tank (in the event of an equipment failure)
or
Antibacterial automatic protection
During the operation of the water heater,
the process of sterilization of water in the
tank is carried out, during which almost all
vegetative forms of microorganisms are
destroyed
or
The first cycle of the mode is activated 3
days after the first switching on of the
water heater After that, if within 30 days
the temperature in the water heater has
not risen above 65° C, then the next cycle is
switched on. If the water heater is turned off,
the antibacterial protection function is also
disabled During the cycle, the temperature in
the water heater rises above 75°C for 1 hour
or
To disable the mode, press and hold the «
» and « » buttons at the same time. The « »
indicator will flash, then turn off. To turn it on
again, press and hold the same buttons, after
which the « » indicator will light up on the
screen
Shutdown
To turn off the water heater, press the «On/
Off» button. The water heater will stop
working, the screen will display the time and
the internal temperature of the water
It is recommended to always disconnect the
water heater from the mains if you do not
plan to use the appliance for some time
13