Philips AWH1620/51 User Manual page 14

Exploitation
1
2
3
4
5
6
13 14
Turning on the water heater
1 Open one of the hot water outlet valves,
then open the cold water supply valve The
electric water heater will begin to fill with
water. When water flows freely from the
hot water tap, this means that the water
heater is completely filled with water and
the hot water outlet tap can be closed
2 Insert the electrical plug into the socket
3. Press the «On/Off» button on the control
panel The screen will display the actual
water temperature, power level, set
temperature, operation mode and time
Attention!
During normal operation, the cold water
supply tap must be set to the «open»
position
12
7 8 9
15 16 17
fig
6
1 Regular service indicator
2 Set water temperature indicator
3 Tank water temperature indicator
4 Time
5 Power mode indicator
6 OptimalTEMP mode indicator
10
7 Turbo mode indicator
11
8 Heating indicator
12
9 Warm indicator
10 Antibacterial mode indicator
11 Timer indicator
12 Time indicator
13 Power mode selection button
14 Button to decrease temperature and
time during related settings
15 Water heater on/off button
16 Button to increase temperature
and time during related settings
17 Operation mode/time setting button
Temperature setting
After turning on the water heater, press
button or
temperature Selection range from 35 to 75 °C
Power mode selection
To select the power mode, press the
«Set» button and select one of the heater
heating power modes:
1 - low (800 W)
2 - medium (1200 W)
3 - intensive (2000 W)
Operating mode selection
Press the «Mode» button to select one
of the three operating modes of the
device: normal mode, «OptimalTEMP»,
«Turbo». When the «OptimalTEMP» and
«Turbo» indicators are off, this is the
normal operation mode, you can adjust
the temperature and select the power
mode. Pressing the «Mode» button again
to adjust the desired water