Hitachi RAK-25PEB Service Manual page 100

1. Press and hold
2. Press [RESET] button on the same time. Release
and (ON) button once Screen 1 appears.
Screen 1
3. Press the button to display
Screen 3
1. Press the Temperature button (
(The shift value is changed with a beep.)
Decrease 3 Decrease 2
from the initial from the initial
shift value setting. shift value setting.
2. Select (FAN SPEED) button to choose Heating Shift or Cooling Shift Mode (Screen 4).
By setting fan speed to HIGH
By setting fan speed to LOW
(HEAT)
Screen 4
NOTE:
1. There are total of 7 shift values ranging from -3 to 3.
2. The displayed shift value,
disappear after 10 seconds
3. The changed shift value will remain unchanged after turned off the power.
4. If "0" is displayed on the remote controller display, it indicates the shift value is now at the initial setting.
(OFF) button and (ON) button.
Screen 2
fan mode (Screen 3).
or ) to change the shift value.
Decrease 1 The initial
from the initial shift value setting.
shift value setting.
or MED , it will go to Cooling Shift mode.
or SILENT , it will go to Heating Shift mode.
(HEAT)
(COOL)
and
100
[RESET] button only, then release
Increase 1 Increase 2
from the initial from the initial
shift value setting. shift value setting.
(COOL)
symbol on the remote controller display will be
(OFF)
Increase 3
from the initial
shift value setting.