Fujitsu AS G12LTCA Series Design & Technical Manual page 29

REMOTE CONTROLLER SIGNAL CODE SETTING
„ „
Use the following steps to select the signal code of the remote controller. (Note that
the air conditioner cannot receive a signal code if the air conditioner has not been set
for the signal code.)
(1) Press the START/STOP ( / ) button until only the clock is displayed on the
remote controller display.
(2) Press the MODE button for at least 5 seconds to display the current signal code
(initially set to ).
(3) Press the SET TEMP. (
→ → → .
Match the code on the display to the air conditioner signal code.
(4) Press the MODE button again to return to the clock display. The signal code will
be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original
•
„
clock display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment.
•
„
/ ) buttons to change the signal code between
- (01 - 26) -