Advertisement
SERVICE
3 REPLACING THE TELESCOPIC SEATPOST CABLE
3.1 Slide the old cable out from the guide in the frame.
3.2 Slide a new cable in the frame through the hole C1 and pull it out through the head tube upwards.
3.3 Slide the cable in through the hole C2 and pull it through the seatpost tube.
C1
4 FASTENING THE CABLES, HYDRAULIC HOSE AND DISPLAY CABLE
4.1 Fasten the cables, hydraulic hose and display cable to the docking station bar using tying strips.
4.2 Tighten the telescopic seatpost cable so that it would remain movable.
4.3 Put the foam Jagwire SFA07A5M sleeve on the cables, hydraulic hose and display cable in length only up to
the headset.
C2
5 PULLING THE CABLES, HYDRAULIC HOSE AND DISPLAY CABLE THROUGH
THE HEADSET AND SPACER RINGS
5.1 Pull the cables, hydraulic hose and display cable through the headset bearing lid and spacer rings so that the
telescopic seatpost cable and display cable would be positioned on the right-hand side when viewing from the
front (1).
5.2 Pull the shifting cable and rear brake hydraulic hose through so that they would be positioned on the left-hand
side when viewing from the front (2).
COMPATIBILITY
Front
Brake Rotors
Rear
Tyre
Chainring
1×
Crankset
Headset
Bottom Bracket
Seatpost Clamp
Ø 34.9 mm
Seatpost
Ø 30.9 mm
Fork
1
2
Ø 160 -180 mm
Ø 140 -180 mm
max. 29 x 2.60"
max. number of teeth 38
Q factor min. 168 mm
ACROS AZX-581, ZERO STACK, 1-1/8"X1.5", BLOCKLOCK
Shimano STePS Middle Drive Unit
min. clamp height 10 mm
min. insertion
100 mm / 15.5"-21.0"
/ frame size
140 mm / 15.5"
max. insertion
175 mm / 17.5"
/ frame size
225 mm / 19.0"
270 mm / 21.0"
Travel 65 mm
Advertisement
