Fujitsu AR G45LMLA Series Design & Technical Manual page 30

4) Room temperature cotrol for Heating
Depending on the installed environment, correction of the room temperature sensor may be required.
Select the appropriate control setting according to the installed environment.
Setting Description
Standard

Lower control
Slightly higher control
Higher control
5) Auto restart
Enable or disable automatic restart after a power interruption.
Setting Description
Enable

Disable
* Auto restart is an emergency function such as for power outage etc.
Do not attempt to use this function in normal operation.
Be sure to operate the unit by remote controller or external device.
6) Indoor room temperature sensor switching
(Only for wired remote controller)
When using the Wired remote controller temperature sensor, change the setting to "Both" (01).
Setting Description
Indoor unit

Both
00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller are active.
*Remote controller sensor must be turned on by using the remote controller.
7) Cool air prevention
This setting is to disable the cold air prevention function during heating operation. When disabled, the fan setting will always follow the
setting on the remote controller. (Excluding defrost mode).
Setting Description
Enable

Disable
8) Remote controller custom code
(Only for wireless remote controller)
The indoor unit custom code can be changed.
Select the appropriate custom code.
Setting Description
A

B
C
D
9) External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Setting Description
Operation/Stop mode

(Setting prohibited)
Forced stop mode
(  . . .Factory setting)
Function Numbe Setting Value
00
01
31
02
03
(  . . .Factory setting)
Function Number Setting Value
00
40
01
(  . . .Factory setting)
Function Number Setting Value
00
42
01
(  . . .Factory setting)
Function Number Setting Value
00
43
01
(  . . .Factory setting)
Function Number Setting Value
00
01
44
02
03
(  . . .Factory setting)
Function Number Setting Value
00
46 01
02
- (01 - 27) -