Siemens EX8 LY Series Instruction Manual page 46

Trouble shooting
en
Indicator/symbol
The indicator on the sensor
flashes twice
The indicator on the sensor
flashes three times
"Š‹‹‹
"Š‹‚‹
—...‹‹
š"
Do not place hot cookware on the control panel.
Notes
If appears on the display, press and hold the
"
■
button for the relevant cooking zone in order to read
the fault code.
If the fault code is not listed in the table, disconnect
■
the hob from the mains power supply and wait
30 seconds before reconnecting it. If this code is
displayed again, contact the technical after-sales
service and specify which fault code has appeared.
If a fault occurs, the appliance will not switch to
■
standby mode.
46
Possible cause
The battery in the temperature sensor has
almost run out. You may be interrupted the next
time you cook by the battery running out.
The wireless connection to the temperature sen-
sor has been broken.
The operating voltage is incorrect/outside of the
normal operating range.
The hob is not connected properly
Demo mode is activated
Remedial action
Replace the 3 V CR2032 battery. See the section entitled
~ "Changing the battery"
Press and hold the symbol on the temperature sensor for 8-10
seconds and then reconnect the temperature sensor to the hob.
See the section entitled ~ "Connecting the wireless
temperature sensor to the control panel"
Contact your electricity supplier.
Disconnect the hob from the power supply. Check that it has
been connected as shown in the circuit diagram.
Disconnect the hob from the power supply. Wait for 30 seconds
before reconnecting it. Touch any touch control in the next
3 minutes. Demo mode has now been deactivated.