Energy Consumption Indicator; Cookware Check - Siemens EX8 LY Series Instruction Manual

[Energy consumption
indicator
T his function indicates the total amount of energy
E n e r g y c o n s u m p t i o n i n d i c a t o r
consumed by this hob the last time it was used for
cooking.
Once the hob is switched off, the energy consumption
is displayed in kilowatt hours (e.g.
seconds.
The accuracy of the information displayed depends on
the voltage quality of the mains power supply, among
other factors.
You can find out how to switch this function on in the
section on ~ "Basic settings"
. kWh) for 10
‚ ‹‰

Energy consumption indicator

tCookware check
T his function can be used to check the speed and
C o o k w a r e c h e c k
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
Correctly position the pot with approximately 200 ml
1.
of water, at room temperature, on the most suitable
cooking zone for the diameter of the bottom of the
pot.
Go to the basic settings and select the setting
2.
Press the programming area.
3.
cooking zone displays.
The function has now been activated.
After 10 seconds, the cooking result and the speed of
the cooking process appear in the visual displays for
the cooking zone.
Check the result using the following table:
Result
The cookware is not suitable for the hotplate and will therefore
‹
not heat up.*
The cookware is taking longer to heat up than expected and the
‚
cooking process is not going as well as it should.*
The cookware is heating up correctly and the cooking process
ƒ
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
To reactivate this function, touch the settings range.
Notes
The flexible cooking zone only counts as a single
■
hotplate; place no more than one item of cookware
on it.
If the diameter of the hotplate used is much smaller
■
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
■
section on ~ "Basic settings".
You can find information on the type, size and
■
positioning of the cookware in the sections on
~ "Induction cooking" and ~ "Flex Zone".
en
.
™‚ ƒ
flashes in the
A
41