Toro TimeCutter ZS 4200S Operator's Manual page 44

Figure 66
1. Blades front to rear
2. Outside cutting edges
Leveling from Side to Side
1. Move to the left side of the machine.
2. Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to Adjusting the Anti-Scalp Rollers (page
3. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page 22).
4. Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets (Figure
5. Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (Figure 67).
3. Measure from the tip of the
blade to the flat surface
here.
Adjusting the Height of Cut
67).
g294046
1. Wood block—6.6 cm
(2-5/8 inches) thick
6. Remove the hairpin cotter and washer from the
lower lift-arm pin
23).
1. Height-of-cut plate
2. Hairpin cotter
7. Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
44
Figure 67
2. Wood block—7.3 cm
(2-7/8 inches) thick
(Figure 68).
Figure 68
3. Washer
(Figure 69).
g294196
g294197