Table of Contents
Advertisement
Additional programme settings
en
ñ Finished in
ñ Finished in
Before starting the program, you can
preselect the program end ("Ready in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
Select a program.
1.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
Press the ñ Finished in button
2.
repeatedly until the required number
of hours is displayed.
Press the A Start/Reload button.
3.
The door will be locked.
The selected number of hours (e.g. 8
h) is shown in the display panel and
counts down until the wash program
starts. The duration of the program is
then displayed.
During the timer count-down, you can
change the preselected number of
hours as follows:
Press the A Start/Reload button.
1.
Use the ñ Finished in button to
2.
change the number of hours.
Press the A Start/Reload button.
3.
During the timer count-down, you can
add or remove laundry as required:
Press the A Start/Reload button.
1.
Open the door and add or remove
2.
laundry.
Close the door.
3.
Press the A Start/Reload button.
4.
The length of the program is
Note:
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
Program settings,
■
Detergent dosage (additional rinse
■
cycles if required due to foaming),
Load size/type of textiles (longer
■
washing for higher load and for
textiles which absorb more water),
26
Imbalances (e. g. due to fitted
■
sheets) are offset with several start-
ups of spin cycles,
Fluctuations in power supply,
■
Water pressure (infeeding speed).
■
\
Additional programme
settings
You can find possible additional
Note:
A d d i t i o n a l p r o g r a m m e s e t t i n g s
programme settings in the overview;
these differ depending on the model.
GSpeed/F Eco
(GSpeed/F Eco)
Button with two possible settings for
adapting the selected programme:
G Speed
■
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more
energy than, the selected
programme, without the GSpeed/
F Eco setting.
Do not exceed the maximum
Note:
load.
F Eco
■
Energy-optimised washing by
reducing the temperature while
achieving a washing result that is
consistent with the selected
programme, without the GSpeed/
F Eco setting.
Select the button to do this. First of all,
you can select the G Speed setting. If
you select the button again, the F Eco
setting is active. The respective symbol
is shown in the display when the setting
is activated.
If you select the button again, no setting
is active.
Advertisement
Table of Contents
