Perform the following steps before carrying out adjustments.
1. Turn ON the power of the unit, set disc to disc table No. 92,
and perform chucking.
2. Turn OFF the power.
3. Remove the case.
[STOP]
4. While pressing the
The test mode is set.
5. The I/u button LED (STANDBY) starts blinking.
(Test mode)
Note 1: The cam will start rotating when the
button is pressed continuously in the test mode.
Note 2: If the power cannot be supplied, the cam can be rotated by rotat-
ing the pulley with your finger.
SECTION 5
MECHANICAL ADJUSTMENTS
button, turn ON the I/u button.
[GROUP 1]
[GROUP 5]
or
LED (STANDBY)
1/u
1/u button
GROUP 1
button
GROUP 5
button
cam
– 13 –
p
STOP button
GROUP 1 button
GROUP 5 button
pulley