Table of Contents
Advertisement
Aging Method
[COMMAND MODE]
1. Change the
[CD1]
.
2. Turn ON the power of the unit. Open the front cover.
[AGING START]
3. Press the
for aging mode (J-2501-123-A).
4. When the disc set mode is set, the · and P LEDs blink.
5. Rotate the JOG dial. The slits (No. 40, 80, 120, 160, 200) for
setting the discs will come forward. Insert the discs into these
slits. Do not set the discs in other slits.
6. Set whether the self-protection function during errors is
equipped with the unit. Press the
PEAT" is displayed on the Fluorescent indicator tube, it means
the function is provided. If "REPEAT" is not displayed, it
means the function is not provided.
7. Press the · button.
8. The · LED blinks, the aging mode is set, and aging is
started.
9. The aging cycle lasts 3 minutes. If errors occur during aging,
the error number will be displayed on the Fluorescent indica-
tor tube. (Refer to the following table for the details of the
errors.)
10. Aging will be repeated as long as no errors occur.
11. After each aging cycle, the number displayed on the Fluores-
cent indicator tube will increase.
12. To end aging, press the I/u button
Error Display
1 2 0
E r r 0 1
Disc number
Error code
Error code
Code number
Err 01
DISC sensor check 1
Err 02
DISC sensor check 2
Err 03
Table operation check 1
Err 04
Table operation check 2
Err 05
Loading operation check 1
Err 06
Loading operation check 2
Err *1
BU related check 1
Err *2
BU related check 2
Err *3
BU related check 3
Err *4
BU related check 4
Err *5
BU related check 5
Err *6
BU related check 6
Err *7
BU related check 7
The * numbers mean the following according to the state of the unit during aging
2 : From checking to end of TOC read
3 : From end of TOC read to end of last track playback
4 : From end of last track playback to end of first track playback
switch (S901) on set to
button of the remote commander
[REPEAT]
button. If "RE-
Name
No disc in the specified slit
Disc in other slits
Table motor current over
No table sensor input
Load in timeover
Load out timeover
Access timeover
High speed search NG
Q data read error
BU operation (from focus search to until signal can be read) timeover
GFS monitor error
Focus cannot be imposed by focus search
Auto focus bias adjustment cannot be performed
– 12 –
Contents
Advertisement
Table of Contents
