Rowenta AU5020 Instructions For Use Manual page 16

EN
Installation 1 - mobile installation
1/ Click the exhausted nozzle (#14) to the exhausted connector
2/ Slide the other exhausted connector (#12) to the air outlet (#7) on the rear of the unit (Fig 3)
Extend hose (#11) to desired length and position the exhausted nozzle (#14) through an open window
as shown on fig.4.
Fig. 3
INDOOR
Fig. 4
Semi-permanently installation
If required, your appliance can also be installed semi permanently (Fig. 5)
Proceed as follows:
• Drill a hole in an outside wall or through a window pane. Ensure the MIN / MAX dimensions for the
hole size and its position are adhered to. (Fig. 6 and 7)
• Fit the wall flange accessory (#15) provided in the hole.
• Insert another end of the hose assembly to the fixture previously fit on the wall a shown in (Fig. 6)
When the hose is not in use, place the cap (#15) on connector to cover the hole on the wall.
NOTE: When installing the air conditioner semi permanently, to maintain the balance of air pressure
between indoors and outdoors always leave an internal door slightly open.
MIN 30cm MIN 30cm
Fig. 5
16