Maintenance Instructions - Sena CN02 Instruction Manual

NOTE: Do not run for more than 10 minutes. Allow it to cool down for 10 minutes before
using again.
USING WORK LIGHT
a. Press the working light button switch, work light will begin to work.
b. Press and release the button again, the work light will flash for alert use.
c. Press and release the button again, the work light will shut off.
d. Recharge the jump starter as soon as possible after use the work light.
NOTE: If internal battery voltage is too low, the work light will shut off automatically.
USING 5 V USB POWER
The USB power outlet provides a maximum of 5 V DC/2.1 Apower to an external
USB-powered device.
a. Plug the USB-powered device into the USB power outlet.
b. Press and release TEST/USB button, then Indicator LEDs will show voltage level.
c. Turn the device on.
d. Reverse these steps after using the USB power.
e. Recharge the unit as soon as possible after using the USB power.
NOTE: If internal battery voltage is too low, the USB power will be shut off automatically.
ADDITIONAL FEATURE
LOW VOLTAGE ALARM when using jump starter
When using the unit, for example, turning the Power Switch on, jump starting a vehicle,
using as 12 V Power Outlet, using work light, etc, the microprocessor inside will detect
internal battery voltage automatically. Once the internal battery voltage is too low, Red LED
will flash and alarm will sound to remind you to charge unit immediately. When you stop
using the unit or internal battery voltage is back to normal, the Red Battery Status Indicator
LED will be OFF and the audible alarm will stop.
TO PREVENT SERIOUS INJURY: Turn all switches to OFF position before performing any
inspection, maintenance, or cleaning procedures. TO PREVENT SERIOUS INJURY FROM
TOOL FAILURE: Do not use damaged equipment. If noise or vibration occurs, have the
problem corrected before further use.
1. BEFORE EACH USE, inspect the general condition of the unit. Check for loose hardware,
misalignment or binding of moving parts, cracked or broken parts, damaged electrical
wiring, and any other condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces of the tool with clean cloth.
3. Protect from sunlight and moisture.
4. LEAD-ACID BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY. Do not short
terminals. Do not incinerate.
20

5. MAINTENANCE INSTRUCTIONS