Page 1
VESA adapter Assembly instructions The VESA adapter is compatible with the following products from (hp.com): OMEN X 25, OMEN X 25f The VESA adapter allows you to conveniently mount your HP OMEN brand monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and nuts.
Assembly instructions Important Safeguards Please read these instructions carefully and keep them for future reference. If you pass the product on to third parties, these instructions should also always be given. Failure to follow these instructions may result in injury or damage to people and the product, for which we cannot accept any liability.
For the disposal of this product we recommend to contact the responsible local authorities or disposal services. They can provide you with detailed information on available disposal options and recycling centers in your area. 4. Manufacturer Information 3idee Technologies S.à r.l. 5 Um Lenster Bierg L-6125 Junglinster Luxembourg 5.
Assembly instructions Horizontal / Vertical Alignment Please note: Not all VESA adapters and monitors are designed for vertical (upright) orientation. This limitation is often due to the specific geometry of the adapter or monitor. Do not ignore this information, as the load limit of the adapter can quickly be exceeded if not installed properly. We are continuously working on developing monitors and adapters that are also suitable for vertical orientation.
Step 2 Now pull out the base of your monitor upwards. (Figure 2) Figure 2 Step 3 Now insert the 3idee VESA adapter into your HP Omen monitor. (Figure 3) Figure 3 Step 4 Now you can reuse the two screws you loosened earlier to attach the VESA adapter to your monitor.
Page 7
Assembly instructions Step 5 Please check if you have fastened the two screws correctly. (Figure 5) Figure 5 Step 6 For this step we recommend a 2nd person. Now lift the monitor and hold it to your monitor mount. Fasten the VESA adapter with the 4 included M4x14 screws (screw bag: SP2).