Table of Contents
Advertisement
Internal fail. No commu-
nication between elec-
tronic elements of the
appliance.
The mains supply is un-
stable.
If the display shows other alarm codes, deactivate and activate the appliance. If
the problem continues, contact the Authorised Service Centre.
In case of different problem with the washing machine check the table below for
possible solutions.
Problem
The programme does
not start.
The appliance fills with
water and drains imme-
diately.
The spin phase does
not operate or the
washing cycle lasts lon-
ger than usual.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise and vi-
brates.
•
The programme was not finished properly or the appliance stopped
too early. Switch the appliance off and on again.
•
If the alarm code appears again, contact the Authorised Service Cen-
tre.
•
Wait until mains supply is stable.
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been touched.
•
If the delay start is set, cancel the setting or wait for the end of count-
down.
•
Deactivate the Child Lock function if it is on.
•
Check the position of the knob on the selected programme.
•
Make sure that the drain hose is in the correct position. The hose may
be positioned too low. Refer to "Installation instruction".
•
Set the spin programme.
•
Make sure that the drain filter is not clogged. Clean the filter, if neces-
sary. Refer to "Care and cleaning".
•
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
•
Make sure that the couplings of the water hoses are tight and there is
not water leakages.
•
Make sure that the water inlet hose and the drain hose have no dam-
ages.
•
Make sure you use the correct detergent and the correct quantity of it.
•
Make sure that a washing programme that ends with water in tub, has
not been selected.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the drum.
•
Make sure the levelling of the appliance is correct. Refer to "Installa-
tion instruction".
•
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
•
Add more laundry in the drum. The load may be too small.
Possible solution
47
Advertisement
Table of Contents
