Table of Contents
Advertisement
ASSEMBLY
3.
Remove sprocket guard nuts (D)
and remove sprocket guard (E).
4.
Remove guide bar (F) and saw
chain if necessary.
Note: See "Maintenance" section
for guide bar/saw chain
maintenance procedures.
5.
Unlock the chain brake.
6.
Mount guide bar (F) and saw
chain on guide bar studs (G) and
slide toward sprocket (H) to
make saw chain installation
easier. Install chain with cutters
on top of guide bar facing
forward.
7.
Install the sprocket guard (E)
over the guide bar studs (G).
Make sure chain tension adjuster
pin (I) fits into the guide bar
adjuster hole (J). Tighten
sprocket guard nuts (D) finger
tight.
8.
Adjust saw chain tension, as
instructed in "Adjusting Chain
Tension".
24
Unlock Chain Brake
C
E
H
E
© 10/23 ECHO Incorporated
CS-3410
F
D
J
I
G
F
D
X7503361801
Advertisement
Table of Contents
