Table of Contents
Advertisement
Inspecting the Belts
Inspect all belts every 100 hours.
Check belts for cracks, frayed edges, burn marks, or any
other damage. Replace damaged belts.
Replacing the Mower Belt
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn mower belt. Replace the mower belt if any
of these conditions are evident.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the belt covers (Fig. 67).
4. Loosen the nut securing the idler plate and move the
idler plate to relieve the belt tension on the idler
pulley, then remove the worn mower belt (Fig. 69).
5. Install the new mower belt around the mower spindle
pulleys, mower idler pulley, into the belt guides, into
rear idler arm assembly, and the clutch (Fig. 66).
Important
Check the amount of twist in the belt
between the pulleys. Make sure it is only what is specified
in Figure 66.
5
3
2
Figure 66
1. Clutch
2. Mower belt
3. 1/4 turn belt twist
6. Adjust the belt tension, refer to Adjusting the Mower
Belt Tension; page 49.
7. Install the belt covers and close the latches (Fig. 67).
1
3
3
4
3
4
6
m–6825
4. Belt guide
5. Mower spindle pulley
6. Mower idler pulley
2
1
Figure 67
1. Belt cover
Adjusting the Mower Belt
Tension
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the transport position.
Important
Check the amount of twist in the belt
between the pulleys. Make sure it is only what is specified
in Figure 66.
Important
Check and make sure the belt is installed
into both the front and rear belt guides (Fig 68).
4. Check the belt tension. The spring loaded idler center
bolt needs to be near the top alignment hole in left
support plate (Fig 68).
3
1
Figure 68
1. Center bolt
2. Alignment hole
49
1
m–6824
2. Latch
1
2
M–4417
3. Left support plate
4. Spring loaded idler
Advertisement
Table of Contents
