Table of Contents
Advertisement
Available languages
Available languages
Preparing chemicals
1.
Prepare chemical solutions following the
chemical manufacturer's instructions.
Prepare solution only enough for the job at
2.
hand so that no solution is left over.
3.
Mix chemicals only by following instructions.
Wrong mixtures can produce toxic fumes or
explosive mixtures.
4.
Never spray undiluted chemicals.
5.
Prepare solution and fill the container out-
doors only in a well-ventilated place.
Storing chemicals
1.
Do not store spray solution in the container for
more than one day.
2.
Always store and transport spray solution only
in approved containers.
Never store or transport the spray solution in
3.
containers intended for foods, drinks or animal
feed.
Do not store or transport spray solution with
4.
foods, drinks or animal feed.
5.
Keep spray solution out of the reach of chil-
dren, other unauthorized people and animals.
6.
Store the spray solution in a locked place
secured against unauthorized use.
Disposing of chemicals
1.
Never dispose of residual chemicals or con-
taminated rinsing solutions in waterways,
drains, sewers, street gutters, manholes or the
like.
2.
When disposing of contaminated rinse,
observe your all applicable laws, regulations
and ordinances.
3.
Strictly observe the precautionary instructions
of the chemical manufacturer.
Filling the tank
1.
Make sure that the draining lever and nozzle
lever are closed.
2.
Before using the mist blower with chemicals,
fill the tank with fresh water to assure that
you have assembled it properly and practice
spraying. Also, check for any leaks at this
time. When thoroughly familiar with the mist
blower operation, follow normal operating
procedures.
3.
Fill the tank in well-ventilated areas or
outdoors.
4.
Do not use flammables in the mist blower,
which may cause explosion resulting in seri-
ous or fatal injury.
5.
Do not use caustic or corrosive materials in
the mist blower, which could result in damage
to the machine.
6.
Do not use liquid with temperature exceeds 50
°C (122 °F) to reduce the risk of scalding and
damage to the machine.
7.
To fill the tank, place the mist blower on a level
surface. To reduce the risk of contaminating
the surrounding environment, be careful not to
overfill the tank with chemical solution.
8.
To reduce the risk of injury, do not fill the tank
while wearing the machine on your back.
9.
If you fill the solution container with a hose
attached to a central water supply, be sure the
end of the hose is out of the solution to reduce
the risk of backflow.
10. Calculate the correct amount of chemical solu-
tion so that it is used up at one time, with no
extra solution left over in the tank.
11.
After filling, tighten the tank cap firmly.
12. Check for leakage while refilling and during
operation. A leak from the tank or a loose fit-
ting could soak your clothing and come into
contact with your skin.
13. Fill the tank with liquid according to operator's
body size or strength.
Operation
1.
Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
Switch off the machine and remove the battery
2.
cartridge and make sure that all moving parts
have come to a complete stop
whenever you leave the machine.
•
•
before clearing blockages.
•
before checking, cleaning or working on
the machine.
if the machine starts to vibrate
•
abnormally.
3.
Operate the machine only in daylight or in
good artificial light.
4.
Do not overreach and keep proper balance and
footing at all times.
5.
Always be sure of your footing on slopes.
Walk, never run.
6.
7.
Keep all cooling air inlets clear of debris.
8.
Never spray in the direction of bystanders.
Operate the machine in a recommended posi-
9.
tion and on a firm surface.
10. Do not operate the machine at high places.
11.
Never point the nozzle at anyone in the vicinity
when using the machine.
12. Never block suction inlet and/or mist blower
outlet.
Be careful not to block suction inlet or
•
mist blower outlet with dust or dirt when
operating in dusty area.
Do not use nozzles other than the nozzles
•
provided by Makita.
13. Do not operate the machine near open window,
etc.
14. Operating the machine only at reasonable
hours is recommended - not early in the
morning or late at night when people might be
disturbed.
15. If the machine strikes any foreign objects or
should start making any unusual noise or
vibration, immediately switch off the machine
to stop it. Remove the battery cartridges
from the machine and inspect the machine
for damage before restarting and operating
the machine. If the machine is damaged, ask
Makita Authorized Service Centers for repair.
16. Do not insert fingers or other objects into
suction inlet or mist blower outlet.
5 ENGLISH
Advertisement
Table of Contents
